Ιδρυματικό Αποθετήριο
Πολυτεχνείο Κρήτης
EN  |  EL

Αναζήτηση

Πλοήγηση

Ο Χώρος μου

Optimization of electrocoagulation (EC) process for the purification of a real industrial wastewater from toxic metals

Gidarakos Evaggelos, Chachladakis Ioannis, Gatsios Evaggelos

Πλήρης Εγγραφή


URI: http://purl.tuc.gr/dl/dias/9D1BD685-1F5A-44C0-A48E-3D1F1F6CFB7F
Έτος 2015
Τύπος Δημοσίευση σε Περιοδικό με Κριτές
Άδεια Χρήσης
Λεπτομέρειες
Βιβλιογραφική Αναφορά E. Gatsios, J. N. Hahladakis and E. Gidarakos, "Optimization of electrocoagulation (EC) process for the purification of a real industrial wastewater from toxic metals", J. Environment. Manage., vol. 154, pp. 117-127, May 2015. doi:10.1016/j.jenvman.2015.02.018 https://doi.org/10.1016/j.jenvman.2015.02.018
Εμφανίζεται στις Συλλογές

Περίληψη

In the present work, the efficiency evaluation of electrocoagulation (EC) in removing toxic metals from a real industrial wastewater, collected from Aspropyrgos, Athens, Greece was investigated. Manganese (Mn), copper (Cu) and zinc (Zn) at respective concentrations of 5 mg/L, 5 mg/L and 10 mg/L were present in the wastewater (pH = 6), originated from the wastes produced by EBO-PYRKAL munitions industry and Hellenic Petroleum Elefsis Refineries. The effect of operational parameters such as electrode combination and distance, applied current, initial pH and initial metal concentration, was studied. The results indicated that Cu and Zn were totally removed in all experiments, while Mn exhibited equally high removal percentages (approximately 90%). Decreasing the initial pH and increasing the distance between electrodes, resulted in a negative effect on the efficiency and energy consumption of the process. On the other hand, increasing the applied current, favored metal removal but resulted in a power consumption increase. Different initial concentrations did not affect metal removal efficiency. The optimal results, regarding both cost and EC efficiency, were obtained with a combination of iron electrodes, at 2 cm distance, at initial current of 0.1 A and pH = 6. After 90 min of treatment, maximum removal percentages obtained were 89% for Mn, 100% for Cu and 100% for Zn, at an energy consumption of 2.55 kWh/m3.

Υπηρεσίες

Στατιστικά